Moving to the Slip
Lowering the Boat
Slipping into the Water
Saturday, May 20, 2017
Bottom Paint, Epoxy, and Zincs
We were out of the water for 3 weeks completing the watermakers install. We had a bad discovery that we did not have an epoxy barrier coat so we sanded the bottom and applied 3 coats of epoxy. Then 2 coats of anti-fouling paint. Big (and expensive) job.
Bottom After All the Work
New Zincs on the Thruster
Cleaned Up Prop
Zinc on Propellor Shaft
Zinc Block on the Rudder Connection to the Keel
Ready to Go Back in the Water
WATERMAKER INSTALL COMPLETE
Our Aquamaax watermaker is now fully functional. We will be testing it over the next couple of months especially when we are off cursing in a few weeks time.
Subscribe to:
Posts (Atom)
COMPLETE THE STORY
Hello all. I must admit to being a bit reticente in completing the story of our trip to Mexico. It is marred by an incident of mental hea...
-
OK, here is the sequence of events: 2013 installed a new ICOM M802 SSB radio complete with SCS Pactor Modem. This included a GANS split... -
We have our SSB installed, but it still needs to be grounded. That should be done shortly, but the process of making our Mac talk to the S... -
Hello all. I must admit to being a bit reticente in completing the story of our trip to Mexico. It is marred by an incident of mental hea...